User's Manual

8 Replacing a Failed Subscriber Unit
If it has been determined that the subscriber’s outdoor unit failed, then the follow this
procedure:
1) Bolt a spare bracket under but touching the existing bracket, and orient it
exactly the same.
2) Measure the down tilt. A simple way is to use a ruler and write down the
difference in distance between the upper and lower edges of the antenna
brackets (see Figure 8-1).
3) Remove the coaxial cable, which also powers the unit.
4) Remove the outdoor unit
5) Install the new unit using the above markings and measurements
6) Attach the coaxial cable and tape it for weather
7) Verify service has been restored.
Figure 8-1: Measure CPE top tiltdown.
ARCXtend manual, August 2003 8-1