User's Manual

3) If pole mounted, then add a spare pair of brackets under the AP,
aligned exactly the same. This is a temporary guide for the new unit
(see Figure 7-1).
4) Measure & record the top and bottom to determine downtilt, if any.
(Figures 7-2 & 7-3)
5) If strand mounted, mark the holes on the bracket that have the AP
bolts, then unbolt the AP from the strand brackets. Be sure to leave
the strand brackets undisturbed.
6) Install the new AP, using the above markings
7) Insert the coaxial connector and tape it for weather resistance.
8) Insert local power, if needed, and tape for weather.
9) Verify service has been restored.
7.1 Access Point - Strand Mount
Do not remove the strand-mount brackets. They determine the antenna alignment.
If the AP is locally powered, remove the power connector before the coaxial
connector.
Remove the bolts holding the AP to the brackets and install the new AP.
ARCXtend manual, August 2003 7-3