User's Manual

4.3.6 TX Initialize
The Initialize command forces the software to initialize, also called a Software
Reboot or a Warm Start.
The Access Point Module will return to its last saved settings.
*log0202
AR150TX [02]
Initializing…
(no parameters are displayed)
4.3.7 TX Help
The Help command will cause the active Module to generate a list of allowed system
setup commands.
Invalid or incomplete entries will generate a response that starts with a question
mark and includes the valid entries that the CPU is expecting.
Example:
*log0202 [this typing is not echoed, not shown on the PC screen]
AR150TX[02]>h
List of commands...
*LOGxxxx Log into card
Q Quit
I Initialize
W[addr][data] Write EE Memory
R Read EE Memory
PI1xxxxxx PLL I,F,R,N Regs
T[0-2] text Write a Title line
S Status
B Banner
DAxxxx Downstream Air MHz
DE[Y/N] Downstream Enable
4.3.8 TX Downstream Enable
The Downstream Enable command allows RF power to be transmitted to the
antenna. The parameter is YES or NO.
YES is the normal state.
NO is the factory default to prevent accidental transmissions at the wrong frequency.
ARCXtend manual, August 2003 4-5