User's Manual

ARCXTEND USER MANUAL – R1.4, ISSUE 4

Bit 0: 1 = System Lock Lost

Bit 1: 1 = Hub Dead

Bit 2: 1 = Input voltage outside of tolerance

Bit 3: 1 = Downstream (Transmitter) Over Temperature

Bit 4: 1 = DCE Unlocked or Error

Bit 5: 1 = Upstream (Receiver) Unlocked or Error

Bit 6: 1 = Downstream (Transmitter) Unlocked or Error

Bit 7: 1 = Local modification notification

Alarm Destination Enter the IP address where SNMP traps are to be sent by the

Hub.

Clear Alarms Click on the “Apply” button to clear all alarms. (presented in

the “Event Logs” page)

Real time monitor Click on the “Apply” button to refresh the Real Time Monitor

display.

Burst Override Mode Chose “On” to disable PureBurst and “Off” to enable

PureBurst. When no traffic is present on the upstream cable

interface, PureBurst mutes the interface preventing the

introduction of ingress noise into the cable network.

Firmware Download Information

ARCXtend Id Displays the Hub type, AX1255 or AX1455. This parameter is

used internally by ARCSmart to customize the user interface

based on the Hub type.

TFTP server IP Address Enter the TFTP (Trivial File Transfer Protocol) server’s IP

address.

Firmware Upgrade Filename Enter the file name of the ARCSmart controller firmware to be

downloaded to the Hub.

Start Upgrade Click the “Apply” button to initiate the download. The

download of the new controller firmware will take up to two

minutes. The download can be verified by refreshing the

page. The version number of the downloaded firmware should

be displayed in the Firmware Version Number box under in

the Real Time Monitor Information table.

Arcwave MIB Real Time Monitor Information

Firmware Version Number: Displays the ARCSmart firmware version number.

Hardware Version Number: Displays the ARCSmart AX300 module hardware revision

number.

DCE Lock: Displays the status of the Hub cable network interface in the

downstream direction. It will display “TRUE” if the Hub is