User's Manual

ARCXTEND USER MANUAL – R1.4, ISSUE 4
Copyright 2005 Arcwave, Inc. 39
USER INTERFACE
The Hub contains an HTTP-based web tool that can be used to interface to the unit. Following is a
guide to using this tool. The following functions are supported: System Info, Signal, Event Log,
Maintenance, and Arcwave MIB.
Accessing the Interface
To access the interface you first must be logged onto a computer that is in some way connected to
the Hub. This can be done either directly using the RJ-45 port on the Hub or through the cable
network. Enter the IP address of the Hub (default IP address on the Ethernet interface is
192.168.100.1) into the address bar of your browser and press the enter key on your keyboard.
Figure 5-1: Hub login screen
When the Hub is accessed the user is presented with a login screen (Figure 5-1). The user id is
‘admin” and the password is ‘arcwave” (all lower case without quotes). The user id and password
can be changed using the Maintenance page.
Cable Status Page
Figure 5-2: Cable Status page