User's Manual

7. In the “General Tab” , check the following and enter the specified value
a. 003 Router – Input: Enter router’s IP address (cable IP address) or Gateway for Vyyo
systems.
b. 004 Time Server – Input: NMS’ IP address
c. 006 DNS Server –Enter the IP address of the DNS server (e.g. router or NMS)
d. 066 Boot Server Host Name - Input: NMS’ network ID (name).
OPTIONAL
(DO NOT include if you are going to register modems. See below for more details)
e. 067 Bootfile Name - Input: configuration file the modem loads (e.g. mic1.cfg)
8. When finished Click “Apply” then “OK”. Your window should now look similar to
this:
*Option 003 Router must will be the Gateway IP address for Vyyo systems
10.3 Registering Modems
If you only wish to allow specific modems to be in the network, then you must register the
modem to a specific IP address. Here are the steps to register a modem:
9. Add a new “Reservation” in the Reservations under the Scope, by clicking on
.
June 2003 Page 10-4