User's Manual
Table Of Contents
- Hub Installation Checklist – 6x60-degree
- Link Budget Parameters for 6x60 Hub
- Wireless Cable Modem Configuration – CXC150W
- W-CMTS BSR1000W Setup Guide
- Factory Settings BSR1000W
- Connecting to the BSR1000 CMTS
- Setting the System Passwords
- Configure the Ethernet IP Address
- Configure Cable IP Address
- Configure the CMTS
- Configure Downstream Port
- Configure Upstream Ports:
- Configure Basic Routing
- Save the Configuration
- Creating a static route from the server to the BSR1000
- Windows 2000 DHCP Server
- Time-of-Day Server Setup Guide
- BSR1000W SNMPc View and Community
- SolarWinds’ TFTP-Server
- Cable System Basics
- Reader Feedback
11 Time-of-Day Server Setup Guide
The purpose of this Section is to review installing the TimeSync (RFC 868
16
) server for
Arcwave systems. TimeSync will install on any Windows 2000/NT operating system and
provide the time-of-day server required by DOCSIS.
11.1 Install TimeSync
1. Go to ARCELL / Servers directory, then to Timesync
2. Locate and run Install
11.2 Configure TimeSync
3. Execute which can be found in the Windows Control Panel.
4. Once running click on the Server tab and check Time (RFC868)
5. Click OK to finish
16
RFCs are “standards” set by the Internet Engineering Task Force (IETF) and are available at
http://www.ietf.org/rfc.
June 2003 Page 11-1