User's Manual
Table Of Contents
- Hub Installation Checklist – 6x60-degree
- Link Budget Parameters for 6x60 Hub
- Wireless Cable Modem Configuration – CXC150W
- W-CMTS BSR1000W Setup Guide
- Factory Settings BSR1000W
- Connecting to the BSR1000 CMTS
- Setting the System Passwords
- Configure the Ethernet IP Address
- Configure Cable IP Address
- Configure the CMTS
- Configure Downstream Port
- Configure Upstream Ports:
- Configure Basic Routing
- Save the Configuration
- Creating a static route from the server to the BSR1000
- Windows 2000 DHCP Server
- Time-of-Day Server Setup Guide
- BSR1000W SNMPc View and Community
- SolarWinds’ TFTP-Server
- Cable System Basics
- Reader Feedback
8 Wireless Cable Modem Configuration –
CXC150W
This Section will describe the DOCSIS parameters that are needed for the wireless cable
modem configuration (CM) file. Any standard DOCSIS CM file generator or editor may be
used as long as the minimum parameters are settable. This Section will show how to create
a CM file using the Tality Cable Modem File Generator that is valid for use with any DOCSIS
compliant modem with the BSR1000W.
Button Placement
8.1.1 Creating a New File
With file generator open, click on File → New at the top of the window
8.1.2 Configure Network Access (required)
This option controls the status of the modem’s network interface
Select the Network Access button and set the value to ON (=1), then click Save
June 2003 Page 8-1