Installation Guide

10
OPERATING INSTRUCTIONS
CONTINUED
Humidity Set Control Left/Right (buttons) _____
• The humidity set control buttons are used
to set the desired humidity level.
• The humidity level can be set between
35% RH (Relative Humidity) to 85% RH
(Relative Humidity) in 5% increments.
• For drier air, press the button to the
desired lower RH % level.
• For more humid air, press the button to
the desired higher RH% level.
POWER button __________________________
• Press to turn the dehumidier on and o.
• OPTIONAL FEATURES (Only available on
SOME Models)
PUMP button (on some models) ____________
• Press to activate the pump operation.
• Refer to the next pages for removing the
bucket and discarding the collected water.
• Do not use this operation when the
outdoor temperature is at or below
32ºF (0ºC)
LED Display ____________________________
• Depending on the feature selected, the
LED Display will show the current relative
humidity level in the room ( 35% - 85%),
the auto start/stop setting (0.0~24) while
setting the timer function, as well as the
desired humidity level setting for the
dehumidier. The accuracy of the relative
humidity reading in the room is ±5% for
humidity levels between 30% and 90%
Note: Make sure the pump drain hose is
installed into the unit and the continuous
drain hose is disconnected from the unit
before the pump operation is activated.
When the bucket is full, the pump will
start to operate.