User Manual

REMOVING THE COLLECTED WATER

CONTINUED

Note:

The pump may make a noticeable sound for 3~5 minutes on startup. It is a normal phenomenon.

Check the following things:

• Clean pump lter

• Remove the bucket from the unit, take down the pump and clean the pump lter.

• Check that the pump drain hose is not kinked or blocked.

• Empty the water of the bucket.

• Reinstall the pump hose if it is disconnected from the unit and properly reinstall the bucket.

• Turn on the unit. If the error repeats, call for service.

• Empty the bucket once a week when using the pump drain feature.

• When the pump drain feature is not being used, remove the pump drain hose from the outlet.

• Press the pump drain hose outlet in towards the unit and pull the drain hose out (See Fig.13).

• Be careful to prevent water from leaking onto the oor.

Note:

The pump operation light will blink will at 1Hz if there is an operational failure of the pump.

Please turn off the unit and unplug the power.

Note:

Do not use this operation when the outdoor temperature is equal to or less than 0°C (32°F),

otherwise water will freeze inside the hose resulting in unit failure.