User Manual

REMOVING THE COLLECTED WATER

CONTINUED

Continuous draining

• Water can be automatically emptied into a oor drain by attaching a drain hose (ld≥Φ5/16′′, not

included) with a female threaded end (ID:M=1′′, not included) to the drain outlet at the back of

the dehumidier (See Fig. 8)

• Remove the plastic cover from the continuous drain outlet at the back of the unit and set it aside.

• Connect the drain hose to the drain outlet of the unit and lead the drain hose to the oor drain or

a suitable drainage facility (See Fig. 9)

• Make sure the hose is secure and there are not leaks or kinks that will stop the water from

owing.

• Make sure the hose is angled down or level to allow for good ow of water towards the outlet.

• Select the desired dehumidier setting, humidity level and fan speed.

Pump draining (on some models)

• Water can be automatically emptied into a oor drain or a suitable drainage facility by connecting

the pump drain hose (ΦOD=1/4′′, supplied) with the pump drain outlet as shown in Fig. 12 and

using the pump feature on the dehumidier.

• If a continuous drain hose is being used, remove it from the unit and reinstall the plastic cover to

the continuous drain outlet.

• Connect the supplied the pump drain hose onto the pump drain hose outlet (See Fig 12.)

• Make sure the hose is pushed on to the pump drain outlet to a depth of at least 1/2 inch (approx.

15 mm).

• Direct the drain hose outlet a oor drain or a suitable drainage facility.

• Press the PUMP button on the control panel to start the pump operation

• The pump will start when the bucket is full