Technical data

Onzen Technical Guide North American Topside

Is Sanitizer Being Produced and Delivered to Spa Water?

Step 6. Soware Revision

e soware revision will ash for 5 seconds.

If any keys are pushed at this stage, you will need to re-start the test from

step 1.

Step 7. Conrm Onzen Output Electrode is Releasing a Fine Mist of

SMALL Bubbles

Before touching any spa control keys, locate the Onzen Output

Electrode in the foot well of the spa. ere should be a ne mist of

small bubbles coming from the ing within a minute or two.

If no bubbles are visible, dealer service may be required.

Note: You can still sanitize your spa with granular chlorine!

Step 8. Allow to Produce Sanitizer

If you see bubbles, sanitizer is being produced.

Leave the Onzen system to produce sanitizer for the next few hours

and make sure it does not shut o.

If you do not see these “ne misty small bubbles’ call for service.

Step 9. Reset Filtration Seings

a. Aer a visual check, you can reset your Filter Cycle Duration.

· Fd 1 is suggested.

b. en reset your desired temperature.

Step 10. Install Cabinet Door

Install the cabinet door in front of the Onzen Generator.