Technical data

11
Onzen Technical Guide North American Topside
1.15.2 Fill Spa With Water Power Up Spa and Set Water Temperature
e following steps provide guidance to help establish correct chemically balanced water. To help ensure chemicals
dissolve appropriately it is good practice to rst mix/dissolve the chemical in an uncontaminated container of hot water
before carefully adding to the spa water.
Steps to Fill Spa With Water Power Up Spa and Set Water Temperature
Step 1. Fill Spa Fill your spa through the lter intake as shown
to the appropriate level (just under the head rests). If you have
sediment or high mineral content a “carbon lled pre-lter”, as
pictured, can help. (is is optional and will prolong the ll time).
Step 2. Connect/Turn on Electrical Power to the Spa Once
the spa is lled to the proper level, connect power to the spa in
accordance with the Arctic Spas Owners Manual, and turn the
power on to the spa on.
Step 3. Set Water Temperature Set the water temperature control
on the Topside Controller to the desired temperature (between
100ºF and 104ºF or 38°C and 40°C or).