Use and Care Manual

Operation
PUMP button(optional)
Press to activate the pump operation.
NOTE: Make sure the pump drain hose is
installed into the unit and the continuous drain
hose is removed from the unit before the pump
operation is activated. When the bucket is full,
the pump starts to work. Refer to the next pages
for removing the collected water. Do not use this
operation when the outdoor temperature is equel
to or less than 0ºC (32ºF).
COMFORT button
Press to activate the comfort dehumidifying
operation.
NOTE: On this operation,the unit can not be set
humidity level.
FILTER button
The check filter feature is a reminder to clean the
Air Filter for more efficient operation. The Filter
light(Clean filter light) will illuminate after 250 hours
of operation. To reset after cleaning the filter, press
the Filter button and the light will go off.
CONTINUE button
Press to activate the continuous dehumidifying
operation.
7
NOTE: The control panel of the unit you purchased may be look like one of the followings:
On
Off
Full
Auto defrost
On
Off
Full
Defrost
TURBO button
Control the fan speed. Press to select either
High or Normal fan speed. Set the fan control
to High for maximum moisture removal. When
the humidity has been reduced and quiet ope-
ration is preferred, set the fan control to Normal.