Use and Care Manual

9
Operation
LED display
Shows the set % humidity level from 35% to 85%
or auto start/stop time (0~24) while setting, then
shows the actual (±5% accuracy) room % humidity
level in a range of 30% RH(Relative Humidity) to
90%RH(Relative Humidity).
Error Codes:
AS- Humidity sensor error;
ES- Temperature sensor error;
E3- Unit malfunction;
EC- Refrigerant leakage detection malfunction
(on some models);
Eb- Bucket is removed or not in right position--
Replace the bucket in the right position.
(only available for the unit with pump feature).
Protection Codes:
P2- Bucket is full or bucket is not in right position--
Empty the bucket and replace it in the right
position.(only available for the uint with no
pump feature.)
P2- Bucket is full -- Empty the bucket.(only
available for the unit with pump feature.)
Note: When one of the above malfunctions occurs,
turn off the unit, and check for any obstructions.
Restart the unit, if the malfunction is still present,
turn off the unit and unplug the power cord.
Contact the manufacturer or its service agents or
a similar qualified person for service.
Removing the collected water
There are three ways to remove collected water:
1.Use the bucket
When the bucket is full, remover the bucket and empty
it.
water outlet
NOTE: If the pump hose drops when you remove the
bucket , you must reinstall the pump hose properly to the
unit before replace the bucket into the unit.
2.Continuous draining
Water can be automatically emptied into a floor drain by
attaching the unit with a water hose (Id≥Φ 5/16",not
included) with a female threaded end (ID:M=1" , not
included). (NOTE: On some models, the female threaded
end is included)
Pump hose
drops
Reinstall pump
hose properly