OPERATOR'S MANUAL
Table Of Contents
58
Previous Main TOC Section TOC Next
Speedometer/LCD
(Analog/Digital)
CF094A
1. Clock/Engine Hour Meter - The
clock function indicates time in the
12 hour mode; the hour meter indi-
cates the total time the ATV has run
and cannot be reset to zero. To set the
clock, use the following procedure.
A. With the ignition switch ON,
press and release the Mode But-
ton (3) until the Clock/Engine
Hour Meter (1) is displayed; then
(if necessary) press and release
the Set/Reset Button (4) to the
clock display.
B. Press and hold the Set/Reset But-
ton (4) until the minutes stop
scrolling and the hour display
starts to scroll. Momentarily
release when the correct hour is
displayed; then repeatedly press
and release the Set/Reset Button
(4) until the correct minutes are
displayed.
NOTE: Approximately two seconds
after releasing either Button, the LCD
will return to normal operation.
NOTE: Clock memory power is
supplied through the 15-amp
accessory fuse and verified during
gauge “power-up” and reset. In the
event of clock memory power fail-
ure (blown fuse, etc.), the gauge
will “power-up,” reset, and shut
down repeatedly until clock mem-
ory power is restored. Always
check the 15-amp accessory fuse
if this gauge condition is noted.
NOTE: The engine hour meter
will not activate until engine speed
exceeds 500 RPM.
2. Fuel Level Indicator - Indicates
approximate amount of gasoline in
the gas tank.
NOTE: When the bottom seg-
ment flashes, approximately 3.5 L
(0.92 U.S. gal.) of gasoline remains
in the tank.
3. Mode Button - Shifts the gauge
through three set-up modes: speedom-
eter/tachometer, distance, and time.
NOTE: The Mode Button must be
pressed and released to shift
modes. Approximately two sec-
onds after the Mode Button is
released, the digital gauge will
return to full display.
4. Set/Reset Button - In conjunction
with the Mode Button, sets and
resets various displays on the digital
gauge. Also used to shift from
speedometer function to tachometer
function on the speedometer/
tachometer gauge.
5. Odometer/Trip Meter (T1 and T2) -
Odometer registers the total distance
the vehicle has traveled. Trip meters
can register two distances (for
instance, T1 could register trip dis-
tance and T2 could register distance
between stops). The trip meters can
be reset while the odometer only
registers accumulated miles/kilome-
ters and the odometer cannot be
reset to zero.
All distances correspond to speedometer
function selected (MPH or km/h).
NOTE: To select the odometer
(ODO), trip #1 (T1), or trip #2 (T2),
press the Mode Button (3) to select
the distance mode; then press the
Set/Reset Button (4) to select the
desired display. Hold the Set/Reset
button down to reset trip meters.
6. Gear Position Indicator - Indicates
which gear is selected.
2011 TRV
2012 TRV