OPERATOR'S MANUAL

52
Previous Main TOC Section TOC Next
The EPS system is battery system pow-
ered; therefore, the battery must be in
good condition and fully charged. Power
delivery and overload protection is pro-
vided by an EPS relay and 30-amp fuse
located under the seat in the Power Dis-
tribution Module (PDM).
2411-213
The system is self-monitored and will
display a “P0635” malfunction code on
the LCD gauge/speedometer should an
EPS system control circuit problem
occur. Do not operate the ATV with a
“P0635” malfunction code displayed.
 NOTE: Turn the key switch to the
OFF position then back to the ON posi-
tion to reset the malfunction code. If
the code continues to be displayed,
take your ATV to an authorized Arctic
Cat Dealer for EPS system servicing
before resuming operation.
In the event of electrical power failure,
the EPS system becomes disabled (simi-
lar to an automobile with the engine shut
off). Steering effort increases but steering
control can be maintained.
Speedometer/LCD
(Digital)
 NOTE: All segments of the LCD
will activate for approximately two
seconds when the ignition switch is
rotated to the ON position.
CF236A
1. Clock/Engine Hour Meter - The clock
function indicates time in the 12-hour
mode; the hour meter indicates the
total time the ATV has run and cannot
be reset to zero. To set the clock, use
the following procedure.
A. With the ignition switch ON,
press and release the Mode But-
ton (3) until the Clock/Engine
Hour Meter (1) is displayed; then
(if necessary) press and release
the Set/Reset Button (4) to select
the clock display.
B. Press and hold the Set/Reset But-
ton (4) until the minutes stop
scrolling and the hour display
starts to scroll. Momentarily
release when the correct hour is
displayed; then repeatedly press
and release the Set/Reset Button
(4) until the correct minutes are
displayed.
 NOTE: Clock memory power is
supplied through the 15-amp acces-
sory fuse and verified during gauge
“power-up” and reset. In the event of
clock memory power failure (blown
fuse, etc.), the gauge will “power-
up,” reset, and shut down repeatedly
until clock memory power is
restored. Always check the 15-amp
accessory fuse if this gauge condi-
tion is noted.
 NOTE: The engine hour meter will
not activate until engine speed
exceeds 500 RPM.
CAUTION
Never operate this ATV with a
“P0635” code indicated on the LCD
gauge/speedometer. This indicates a
malfunction in the EPS system con-
trol circuit and could result in a loss
of power steering assist.
2012 Generic ATV