OPERATOR'S MANUAL

69
Division II - Operation/
Maintenance
Previous Main TOC Section TOC Next
1. Position the ATV on a level floor so
the headlights are approximately 6.1
m (20 ft) from an aiming surface
(wall or similar aiming surface).
ATV-0070C
 NOTE: There should be an aver-
age operating load on the ATV when
adjusting the headlight aim.
2. Measure the distance from the floor
to the mid-point of each headlight.
3. Using the measurements obtained in
step 2, make horizontal marks on the
aiming surface.
4. Make vertical marks which intersect
the horizontal marks on the aiming
surface directly in front of the head-
lights.
5. Switch on the lights. Make sure the
HIGH beam is on. DO NOT USE
LOW BEAM.
6. Observe each headlight beam aim.
Proper aim is when the most intense
beam is centered on the vertical mark
5 cm (2 in.) below the horizontal
mark on the aiming surface.
7. Adjust each headlight by turning the
adjustment knob clockwise to raise
the beam or counterclockwise to
lower the beam until correct aim is
obtained.
CD714A
Fuses
The fuses are located in a fuse block
under the seat. If there is any type of
electrical system failure, always check
the fuses first.
 NOTE: To remove the fuse, com-
press the locking tabs on either
side of the fuse case and lift out.
1411-381
Electrical Output
Terminals
One output terminal for electrical acces-
sories is located on the front wiring har-
ness.
Two output terminals for electrical acces-
sories are located on the front and rear
wiring harnesses. The accessory plug is
located on the right side of the instrument
pod.
CAUTION
Always replace a blown fuse with a
fuse of the same type and rating. If
the new fuse blows after a short
period of use, consult an authorized
Arctic Cat ATV dealer immediately.
2012 700 Diesel