Installation and Maintenance Guide

Raised Walls
Raised walls require hardware that keeps the cover flush against the wall. To accomplish this a steel
cable is used along the wall inside foam along the edge of the cover and is secured by springs on either
end of the raised wall.
First drill 5/8” hole into the raised wall where the snap hooks on underside of cover line up to eyebolt
(always check with builder of raised wall to assure that drilling will not damage surface of wall).
Snap hooks to eyebolts and attach cable at ends where it meets deck.
Cover
Snap hook
Eyebolt
Foam
CARE & MAINTENANCE
Cover must always stretch taut across the pool. After the initial installation, some stretching may occur.
Each spring should be compressed 50%, if needed readjust straps.
Water level in pool can not go below 18” from top, as cover is designed to set down on water with the
weight of snow and ice. Without proper water level, the cover will stretch too far, placing undue strain on
cover and voiding the warranty.
Mesh covers are designed to screen out leaves and large debris. Dust, dirt and other small debris will
filter through cover into pool. Algae will also form under mesh cover without proper chlorinization and
winterization. Solid covers with mesh panel keep most debris out of pool. Solid covers without mesh
drain must have automatic pump on cover and plugged in at all times.
Store the cover in supplied mesh bag when not in use and store off ground to keep mice and other
animals from getting to the cover.
Arctic Armor Safety Covers
1745 Wallace Avenue
St. Charles, Il 60174
1-800-759-0977
Safety Covers 8/24/05 2:14 PM Page 4