Installation Guide

A
B
C
E
F
D
2
2
2
2
2
2
4
5
A. Remove stopper (1) and flange (2).
B. Screw nut (1) all the way down.
Push washer (2) and gasket (3) down.
C. Apply silicone to underside of
flange (1).Insert body (2) into sink.
Screw flange (1) into body (2).
D. Pivot (1) must face faucet. Pull
assembly (2) down firmly and hold
in place.
DO NOT TWIST .
E. Tighten nut / washer / gasket (1),
clean off excess silicone (2).
DO NOT TWIST
F. Remove pivot nut (1). Install
horizontal rod (2) and stopper (3)
as removable (4) or
non-removable(5).
Hand tighten pivot nut (1).
G. Attach horizontal rod (1)
to strap (2) using clip (3).
Insert lift rod (4) into strap
and tighten
Attach supply lines .
Do not overtighten.
Turn water back on.
3
To flush debris from the plumbing
system:
1. Remove the aerator by hand.
2. Run hot and cold water for
one minute.
3. Replace the aerator.
4
Provided with necessary models.
1
Attach the mounting nut to the
hot and cold threaded mounting
shanks and tighten faucet to
basin.
2
Before installing the valves, clean the
water pipe thoroughly to avoid dirt
and deposits.
1
Notes
OPTION: Use silicone under the
base if deck is uneven.
FLUSH SYSTEM/CHECK FOR LEAKS.
Turn on hot and cold water supplies
and flush water lines for one minute.
Check all connections at arrows for
leaks.
Retighten if necessary, but do not
overtighten.
2
1
3
GG
4
5
2
6