Installation Guide

1
3
5
4
2
Select a location on the verticalwall to install
the bracket.
Mark anchor mounting hole locations on wall
as shown , ensure two screw holes are
horizontal.
Drill holes in the finished wall as required.
Press the anchors (1) into the holes.
secure the bracket (2) with the self-tapping
screws (3).
Make sure the bulge on bracket upwards
Slide the extension of the towel bar kit onto
the bracket .
Orient the screw hole of the extension
downwards.
Tighten the screw with the hex wrench to
secure the towel bar kit .
1.Insert the towel bar (3) and(5) into the towel
rack (2)
2. Use a screw driver to tighten the screw (4).
3. Insure the towel bars are firmly installed on
the rack.
These products should be located and mounted to a wall.
While it is possible to mount them to any surface, a stud or concrete mounted product will yield the best results.
These products are not designed or intended for use as a grab bar or support bar. Do not install any of these
products in any area where they are likelyto be used inadvertenrly as a grab bar or support bar.
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Cleaning Instructions:
NOTE:
DANGER:(Risk of personal injury)
24"(612)
unit:inch(mm)
22"(557)
8"(200)
6.3"(161)
3.2"
(81)
2.2"x2.2"
(55x55)
4.1"
(105)
4.9"(125)
4050101
Towel rack