User manual

ZyWAN User Manual Configuring the ZyWAN

Changing a configuration

The configuration details for each Web page are described in the following sections.

To make changes on any page of the configuration:

1 Enter the changes you want to make and click the Submit New Configuration

button.

2 Click on any tab or close the browser. The names and values of the properties are

displayed in a box with the heading New Settings:

By submitting the configuration, the values of all properties on the displayed page

only, are stored in a properties file in permanent memory of the ZyWAN.

3 If there are more changes to be made on a different page of the configuration, click

the Make More Changes button. The Cellular tab is displayed again, so that

another page may be selected and modified.

If changes are not submitted before closing the browser or clicking on

another tab, the changes made on that page are lost. Make sure to save

changes on each page by clicking the Submit New Configuration

button.

If the ZyWAN is not rebooted after all changes have been made, it

continues to operate with its current settings until the next reboot.

4 After all changes have been made, click the Reboot with New Settings button.

The ZyWAN then reboots so that the changes can take effect. The ZyWAN shuts

down and restarts, which may take over a minute. The Web page automatically

attempts to reload at the same IP address after 90 seconds:

Even if no new changes have been made, the ZyWAN may be rebooted

via the Web page by clicking the Submit New Configuration button on

any page, then clicking the Reboot with New Settings button.