Service manual

Configuring the Transportal Interlock Monitor
SM-1H1.0002, Rev. 1, July 2009 4-23
4. Select the communication port activated in TCP-Com and enter the IP address of the
Ethernet port (ETH0 typical) as the “Unit address.” See Figure 4-22. The address data
shown is typical; enter the specific data for this TIM application.
Figure 4-22. Typical MICROLOK II Development System Communications Setup
5. Select “OK.” The “Dev Tool” will show the available MLK unit(s). See Figure 4-23
Figure 4-23. Typical MICROLOK II Development System Site Display