Service manual

Configuring the Transportal Interlock Monitor
SM-1H1.0002, Rev. 1, July 2009 4-21
4. Configure the converter, typically as shown in Figure 4-18 and Figure 4-19. The IP
address data shown is typical; enter the specific data for this TIM application.
Figure 4-18. Typical Serial-to-TCP/IP Converter Configuration
Figure 4-19. Typical Serial-to-TCP/IP Converter I/O Options Configuration
4.4.1.2. Running the MICROLOK II Development System
All features of the MLK Development System (also referred to as “Dev Tool”) for this TIM
application are now available. To access the “Dev Tool”, proceed as follows.
1. Connect the computer to Ethernet port ETH0 (typical) on the TIM. If required, configure
the computer for this TIM application (Refer to Section 4.4.1.1).