Service manual

Configuring the Transportal Interlock Monitor
SM-1H1.0002, Rev. 1, July 2009 4-19
4.4.1.1. Configuring the Local Computer
NOTE
The data shown in these web page views are only representative of
the configuration data required for a specific interlocking. Each
TIM must be configured with interlocking-specific data for that
location.
Each TIM must also be configured with specific network- and
SNMP-host interface parameters for that location.
1. Access the “Local Area Connection Properties” window on the computer being used.
Select “Internet Protocol (TCP/IP).” See Figure 4-15.
Figure 4-15. Typical Local Area Connection Properties