Service manual

Configuring the Transportal Interlock Monitor
4-12 SM-1H1.0002, Rev. 1, July 2009
4.2.2.4. Status Tab
The Status tab shows the current status and configuration of the TIM. The data is shown for
viewing only, and cannot be changed on this screen. See Figure 4-6 for a typical screen and
configuration data.
Figure 4-6. Typical Status Tab
Full Hardware Model – Shows basic hardware data.
Current Software Version – Shows current software version.
Hardware Model – Shows the type of cellular modem installed. Not applicable for this
application.
GPS – Shows the type of GPS hardware installed. Not applicable for this application.
802.11B – Shows if an 802.11b WiFi module is installed. Not applicable for this TIM
application.
Last COM Port – Shows the last available COM port in the TIM. This data is used in
all other configuration menus where a selection of COM port is allowed.
COM3 Type – The COM3 port may be factory-configured as either RS-232 (shown as
RS-232) or RS-485/422 (shown as RS-485).