Service manual

Configuring the Transportal Interlock Monitor
SM-1H1.0002, Rev. 1, July 2009 4-5
NOTE
The data shown in these web page views are only representative of
the configuration data required for a specific interlocking. Each
TIM must be configured with interlocking-specific data for that
location.
Each TIM must also be configured with specific network- and
SNMP-host interface parameters for that location.
• Enable ETH0? (ETH1?) Select “Yes” and configure each port as described below:
Use DHCP? – Select 'No" for this TIM application and enter the following:
IP Address – Enter the numeric address for the TIM. Each field must be a whole
number between 1 and 255.
Subnet Mask – Enter the subnet mask for this network. Each field must be a whole
number between 1 and 255.
Default Gateway – Enter the numeric address of the default gateway (if used) for this
network. Each field must be a whole number between 1 and 255.
Preferred DNS Server – Enter the numeric address of the preferred DNS server (if
used) for this network. Each field should be a whole number between 1 and 255. If
no preferred DNS server is used, each field should be zero (0) or blank.
Alternate DNS Server – Enter the numeric address of the alternate DNS server (if
used) for this network. Each field should be a whole number between 1 and 255. If
no alternate DNS server is used, each field should be zero (0) or blank.
• Run DHCP Server: – Select “No” for this TIM application.