User manual

ZyWAN User Manual Getting started with your ZyWAN

4 Make the following settings for the serial communication, then click the OK

button:

5 If the ZyWAN is already started, press the Enter key to get a login prompt. The

default login is root and the default password is arcom (case-sensitive).

6 After logging into the ZyWAN, type the command ifconfig eth1 at the command

prompt. This shows the current network address which has been assigned to the

ZyWAN by the network:

If the ifconfig command does not show an inet addr address, it may be

that the network does not have a DHCP server, or that security policies

prohibit the ZyWAN from obtaining its address. An address can be

manually set if necessary, by issuing the following command:

ifconfig eth1 ip_address netmask subnet

where ip_address is the actual address on the network,

and subnet is the subnet mask in dotted notation (such as 255.255.0.0).