User's Manual

5634BIF User’s Manual
32
S-Register Range Default Description
S12
0-255
1/50
seconds
50
Escape character guard time
Register S12 controls the time delay required
before and after typing the escape characters.
The default setting, 50, equals one second. To
reduce the chance that transmitted data is
mistaken for escape characters, the S12 value
can be increased, but this makes using the
escape characters time-consuming. If a small
value is used, it may be hard to type the three
escape characters fast enough, especially if the
guard time is less than the time needed to send
1 character at the current transmission speed. If
S12=0 , there will be no time requirement for
typing escape characters.
S14 General Bit Mapped Options Status
Bit 0&1¡ÐMode (%Xn)
0= Invalid
1= Mode 1 (Remote)
2= Mode 2 (Share)
3= Mode 3 (Local)
Bit 2¡ÐExternal line hook
0= On hook
1= Off hook
Bit 3¡ÐLocal line hook
0= On hook
1= Off hook
Bit 4¡ÐCommand echo (En)
0= Disabled (E0)
1= Enabled (E1) (Default)
Bit 5¡ÐTone(T)/Pulse(P)
0= Disabled (E0)
1= Enabled (E1) (Default)
Bit 7¡ÐOriginate/Answer
0= Answer
1= Originate (Default)