User's Manual

5634BIF User’s Manual

operating characteristics from Profile 0.

2. To recall Profile 1 instead of Profile 0, type AT&Y1 instead of AT&Y0.

3.3 Reset and recalling profile

If you prefer, you can use ATZn command to reset the modem and load a stored

configuration profile : For example, to reset your modem and recall Profile 0 :

1. Type ATZ0

2. Press the Enter key.

Returning to the default profile

1. To return to the factory default profile 0:

2. Type AT&F0

Press the Enter key. Your modem returns to basic asynchronous operation, which is the

profile in effect when you received your modem. The following table lists the modem's

default profile.

Setting Default Obtained

from Memory

Auto-answer Disable Yes

Backspace character 08 No

Bell / CCITT compatibility at 1200 bps Bell 212A Yes

Busy signal detect Enabled Yes

Carriage return character 13 No

Line feed character 10 No

Communication rate 57600bps Yes

Data Set Ready option Always Yes

Data Terminal Ready option DTR hang up Yes

Data Terminal Ready pulse width 0.5 seconds Yes

Echo On Yes

Escape character definition 43 (+++) Yes

Guard tones Disabled Yes

Long space disconnect Disabled Yes

Parity None Yes

Pulse make/break ratio 39/61 (US setting) Yes

Responses Word Yes

Response enabled All Yes

RTS-to-CTS delay 50 milliseconds Yes

Speaker status On, but off when carrier

detected

Yes

Speaker volume Medium Yes

Test timer setting 0 second Yes

Wait for carrier after dialing 50 seconds Yes

Wait for dial tone 2 seconds No

Wait for dial tone before dialing Enabled Yes