User's Manual

5634RCS User’s Manual
37
S-
Register
Range Default Description
S10
1-255
tenths
of a
second
14
Carrier loss time
Register S10 sets the time between the loss
of a remote modem's carrier signal and
when the modem disconnects. This allows
the remote modem's carrier signal to
momentarily disappear from the telephone
line without the modem disconnecting.
S11
50-255
ms
95
Touch-Tone speed
Register S11 controls the speed of the
Touch-Tone (DTMF) dialing. Increasing this
value to 255 slows the dialing rate to 1.9
digits per second. Do not select a value less
than 50 milliseconds. (Register S11 does
not effect pulse dialing, which is fixed at 10
pulses per second.)
S12
0-255
1/50
seconds
50
Escape character guard time
Register S12 controls the time delay
required before and after typing the escape
characters. The default setting, 50, equals
one second. To reduce the chance that
transmitted data is mistaken for escape
characters, the S12 value can be increased,
but this makes using the escape characters
time-consuming. If a small value is used, it
may be hard to type the three escape
characters fast enough, especially if the
guard time is less than the time needed to
send 1 character at the current transmission
speed. If S12=0, there will be no time
requirement for typing escape characters.