User's Manual

5634RCS User’s Manual
31
In Data Mode; if reliable mode, send break to the remote system
\K0,\K2,\K4
\K1
\K3
\K5
Enter Command Mode, don't send break to remote modem
Modem clears modem and terminal buffers, and sends break to
remote system
Modem does not clear terminal and modem buffers, and sends
break to remote modem
Modem sends break to remote modem in sequence with any
transmitted data
In Command Mode; if reliable mode, send break to the remote system
\K0 or \K1
\K2 or \K3
\K4 or \K5
Modem clears modem and terminal buffers, and sends break to
remote system
Modem does not clear terminal and modem buffers, and sends
break to remote modem
Modem sends break to remote modem in sequence with any
transmitted data
In Data Mode; if break is received at modem port, send it to serial port
\K0 or \K1
\K2 or \K3
\K4 or \K5
Modem clears modem and terminal buffers, and sends break to
remote system
Modem does not clear terminal and modem buffers, and sends
break to remote modem
Modem sends break to remote modem in sequence with any
transmitted data
MNP/
V.42/V.42bis
Commands
Description
\Nn Set operating mode
Selects the type of asynchronous data connection the modem will
try to establish. A modem that uses V.42 can not communicate
with one using MNP, since the two error correction protocols are
different. However, this command ensures that your modem will
be can automatically communicate with modems that use
V.42bis, MNP, or no error-correction protocol.
0 Normal mode
1 Direct mode
2 reliable mode
3 V.42 auto-reliable mode(default)
4 V.42 reliable mode
5 MNP reliable mode
\Vn
0 Disable single line connect message
1 Enable single line connect message