User's Manual

5634RCS User’s Manual
30
stores in memory position 0 the telephone number 1 818 555
2121, which will be Touch Tone (T) dialed.
Table 5-2. MNP/V.42/V.42bis commands
MNP/
V.42/V.42bis
Commands
Description
%Cn Enable/disable MNP Class 5 data compression
0 Disable data compression
1 Enable MNP 5 data compression
2 Enable V.42bis data compression
3 Enable both V.42bis and MNP 5 data compression.
(default)
%En Line Quality Monitor and Auto-retrain or Fallback/Fall
Forward
This command determines whether your modem retrains
automatically and resynchronizes the flow of data if it detect
telephone-line problems that could adversely affect data.
0 Disable auto-retrain
1 Enable line quality monitor and auto-retrain
2 Enable line quality monitor and fallback/ fall forward.
(default)
%L
Return received line signal level
%Q
Report the line signal quality
%7
Plug and Play serial number
%8
Plug and Play vendor ID and product number
\Bn Send break to remote system
Equivalent to pressing the Break key on a host keyboard. For
standard (non-MNP) or V.42 connections, type a number from 1
to 9 after this command to indicate how long the modem is to
provide the break signal. The number will be multiplied by 100
milliseconds and the break signal provided for that duration.
Default is 0, which sends a break of 300 milliseconds. Ref. “
\Kn
”,
defines how your modem treats breaks.
\Gn Modem port flow control
Controls the modem's DCE flow control feature
0 Turn off port flow control(default)
1 Turn on XON/XOFF port flow control. Use this setting if the
modem is receiving data from the remote system faster
than it can process
\Kn Set break control
Determines the action performed by the modem when it receives
a break from the DTE port or the modem port. The action taken
by your modem depends on the mode that the modem is in, as
shown in the following tables. Default is 5.