User's Manual

25
3 Speaker on until carrier detected but off during dialing (M3)
4,5,6=0 Hayes Smart modem compatibility (X0)
4 Include CONNECT XXX responses (X1)
5 Same as 4 plus dial tone detection (X2)
6 Same as 4 plus BUSY response and blind dialing (X3)
7 Same as 6 plus dial tone detection (X4) – default
7 =0 Undefined
S23 Bit-mapped Register
Bit Function
0,1,2,3= 0 0-300bps DTE data rate
1 1200bps DTE data rate
2 2400bps DTE data rate
3 4800bps DTE data rate
4 9600bps DTE data rate
5 14400bps DTE data rate
6 19200bps DTE data rate
7 34800bps DTE data rate
8 57600bps DTE data rate
9 115200bps DTE data rate
4,5= 0 Use even parity
1 Use none parity
2 Use odd parity
3 Use mark parity
6,7= 0 Mapping to AT&G
S25 Data Terminal Ready Delay
When Modem is on-line, it will ignore a Data Terminal Ready signal lasting less than
the value of this register. In this mode, the values for this register are 0 to 255 in
hundredths of a second, and the default value is 0.05 seconds. If you will be entering
synchronous mode after dialing asynchronously, this register determines how long the
modem waits before looking for the Data Terminal Ready signal. This lets you detach
the asynchronous terminal and connect a synchronous terminal while remaining in the
Data Mode. The default value is 5
Range: 0-255
Default: 5
Units: 0.01 seconds