User's Manual

23
encounters a comma (,) in the dial command string.
Range: 1-255
Default: 2
Units: seconds
S9 Carrier Detect Response Time
Register S9 sets the time the remote modem's carrier signal must be present for the
local modem to recognize it. This feature ensures that your modem does not mistake
a busy signal, ring, or voice for the carrier signal. The value of this register is in tenths
of a second. The default value is 600 ms , although you can change it from 1 to 255.
For example, entering a value 13 means that the remote modem's carrier signal must
be present for 1.3 seconds for the local modem to recognize it. Setting this value
higher increases the chances the modem will not mistakenly identify the carrier signal.
S10 Automatic Disconnect Delay after Carrier Loss
This register sets the length of time, in tenths of a second, that the modem waits
before hanging up after a loss of carrier. This allows for a temporary carrier loss
without causing the local modem to disconnect. The actual interval the modem waits
before disconnecting is the value in register S10.
Range: 1-254
Default: 14
Units: 0.1 seconds
S11 DTMF Dialing Speed
This register determines the dialing speed which is prefixed for each country.
Range: 50-255
Default: 95
Units: 0.001 seconds
S12 Escape Guard Time
This register sets the value (in 20 ms increments) for the required pause after the
escape sequence (default 1 s).
Range: 0-255
Default: 50
Units: 0.02 seconds
S14 Bit-mapped Register
Bit-mapped register S14 lets you control modem echo, responses, dialing method,