User's Manual

&Zn = x Store Telephone Number

This command is used to store up to three dialing strings in the modem

nonvolatile memory for later dialing. The format for the command is &Zn =

stored number where n is the location 0? to which the number should be

written. The dial string may contain up to 31 characters. The ATDS = n

command dials using the string stored in location n.

Result Codes:

OK n = 0, 1, 2

ERROR Otherwise

*In Connect Speed Selection

*I0 Selects connect speed 1200bps

*I1 Selects connect speed 2400bps

*I2 Selects connect speed 4800bps

*I3 Selects connect speed 7200bps

*I4 Selects connect speed 9600bps

*I5 Selects connect speed 12000bps

*I6 Selects connect speed 14400bps

*I7 Selects connect speed 16800bps

*I8 Selects connect speed 19200bps

*I9 Selects connect speed 21600bps

*I10 Selects connect speed 24000bps

*I11 Selects connect speed 26400bps

*I12 Selects connect speed 28800bps

*I13 Selects connect speed 31200bps

*I14* Selects connect speed 33600bps

select V.pcm

*I1 Selects connect speed 28000bps

*I2 Selects connect speed 29333bps

*I3 Selects connect speed 30666bps

*I4 Selects connect speed 32000bps

*I5 Selects connect speed 33333bps

*I6 Selects connect speed 34666bps

*I7 Selects connect speed 36000bps

*I8 Selects connect speed 37333bps

*I9 Selects connect speed 38666bps

*I10 Selects connect speed 40000bps