User's Manual

Qn Result Code Control

Result codes are informational messages sent from the modem and displayed

on your monitor.

Q0* Enables modem to send result codes to the DTE.

Q1 Disables modem from sending result codes.

Result Codes:

OK n = 0, 1

ERROR Otherwise

T Select Tone Dialing

This command instructs the modem to send DTMF tones while dialing.

Vn DCE Response Format

This command controls whether result codes are displayed as words or their

numeric equivalents.

V0 Displays result codes as numeric.

V1* Displays result codes as text.

Result Codes:

OK n = 0, 1

ERROR Otherwise

Wn Result Code Option

W0 Display ”C ONNECT DCE speed?without V42/MNP extended.

W1 Display ”C ONNECT DTE speed?without V42/MNP extended.

W2* Display ”C ONNECT DCE speed?with V42/MNP extended.

W3 Display ”C ONNECT DTE speed?with V42/MNP extended.

Result Codes:

OK n = 0, 1, 2

ERROR Otherwise

Xn Result Code Selection and Call Progress detection

This command enables tone detection options during dialing procedure. As these

functions are chosen, the modem chip set result codes are also affected. Therefore,

this command is frequently used to control the modem chip set responses and dial

tone detection.

Result Codes:

OK n = 0, 1, 2, 3, 4, 5, 6, 7

ERROR Otherwise

Zn Recall Stored Profile

This command instructs the modem chip set to go on-hook and restore the profile