User's Manual

address

For example : setserial ttyS2 uart 16550A irq 5 port 0xe400

3. At path /dev, remove default modem link then link modem to the tty you

assign in step 2

For example : rm modem

ln –s ttyS2 modem

4. Now, you can use minicom to test the modem by type ATI3 to make sure the

modem is Topic modem.

For example : minicom

………………..

ATI3

B. Automatic Mode

1. Copy topic.modem excutable file to /bin

2. Copy script file rc.serial to /etc/rc.d

3. When Linux boot again you can see the message " Setup topic modem …"

or you can run topic.modem directly.

4. You can use minicom to check Topic modem.

1.11 MS-DOS Modem

Driver Installation

Introduction

This program intends to provide the function for hardware resource

configuration via 5634PCV internal modem card. It is only can be executed in

DOS environment, Windows DOS prompt is inhabited to run this program.

Installation

Prior launching the program, 5634PCV PCI modem card must be installed in

the PC in advance. Besides, it can be used to configure the multiple PCI cards.

Configuration

When the program is launched, it will search the 5634PCV PCI card first. If no

card is found, an error message will be shown and the program will be

terminated. If only one card is enumerated, a configuration dialog window will

be popped up immediately. User can set and the IO port address and interrupt

number of PCI card in this configuration dialog. After setting, user may select