User's Manual

file then hit OK. You will be presented with a listing of Topic modems.

Select the model number of your modem and then hit OK.

5. Click Finish and Windows will install the driver, and then finish

booting.

6. To check the modem installation open Control Panel and then

Modems. Click on the Diagnostics tab. Click on the port which lists

your modem. Click on More Info. Your modem should report back

with modem information. Your modem is functioning properly.

1.9 Windows NT 4.0 Modem

Driver Installation

1. Install the PnP modem into an available slot.

2. Insert Setup program for Windows NT drivers’ disk into drive A or B.

3. Execute the “ Setup” program to install the PCI agent driver.

4. Then, after the installation is completed, reboot PC.

5. After PC is rebooted and NT is running, follow the steps described in

section 1.1 to add the modem and its drivers.

NOTE: Microsoft does not support plug and play in Windows NT 4.0.

1.10 Linux Red Hat 6.0

Modem Driver Installation

A. Manual mode:

1. At path /proc, find file pci then use vi editor to find Topic vender ID “ 151f”

and the

I/O-address, IRQ-number Linux assign to Topic modem.

For example : cd /proc

vi pci

…………………………………………

Vendor id=151f. Device id=0.

Medium devsel. IRQ=5.

I/O at 0xe400 [0xe401].

(type :q to quit vi)

2. At path /dev, use setserial tty-number uart 16550A irq IRQ-number port I/O-