User's Manual

If you did not receive a response, make sure your computer is sending

commands to your modem. If this does not solve your problem, contact

your computer dealer.

2. Use your communication software to prepare your computer to dial a call.

Then type AT D x phone number, where x is either T for touch-tone

dialing or P for pulse dialing and phone number is the telephone number

that your modem is using.

For example, if your modem is connected to the telephone line 555-2121

and Touch-Tone dialing is supported in your calling area, type ATDT

5552121.

3. Press the Enter key. You should receive a BUSY response and you should

hear the busy signal through the modem speaker because the modem is

calling itself.

Your modem is now ready for operation. Refer to the manual that came with

your communication software to begin communications. If you will be

communicating directly with your modem, or if you want to find out more about

the modem's operation, proceed to Chapter 2.

1.8 Windows95/98

ModemDriver Installation(PNP)

1. Install the PnP modem into an available slot.

2. Turn On your computer.

3. As you enter Windows you should receive a message saying “ PCI

communication Device” , than “5634PCV V90 modem” .

4. Windows will identify the modem and then present you with three

choices.

Do not install a driver

Driver from disk provided by manufacturer

Select from a list of alternate drivers.

Select Driver from disk provided by manufacturer. Windows will ask

you to insert your disk. Put the disk in your drive and select right inf