User's Manual

27
modifier in seconds. S7 is not associated with the W dial modifier.
Range: 1-255
Default: 45
Units: seconds
S8 Comma Dial Modifier Time
This register sets the time, in seconds, that the modem must pause when it
encounters a comma (,) in the dial command string.
Range: 1-255
Default: 2
Units: seconds
S9 Carrier Detect Response Time
Register S9 sets the time the remote modem's carrier signal must be present
for the local modem to recognize it. This feature ensures that your modem
does not mistake a busy signal, ring, or voice for the carrier signal. The value
of this register is in tenths of a second. The default value is 600 ms , although
you can change it from 1 to 255. For example, entering a value 13 means that
the remote modem's carrier signal must be present for 1.3 seconds for the
local modem to recognize it. Setting this value higher increases the chances
the modem will not mistakenly identify the carrier signal.
S10 Automatic Disconnect Delay after Carrier Loss
This register sets the length of time, in tenths of a second, that the modem
waits before hanging up after a loss of carrier. This allows for a temporary
carrier loss without causing the local modem to disconnect. The actual interval
the modem waits before disconnecting is the value in register S10.
Range: 1-254
Default: 14
Units: 0.1 seconds
S11 DTMF Dialing Speed
This register determines the dialing speed which is prefixed for each country.
Range: 50-255
Default: 95
Units: 0.001 seconds