User's Manual

15
Qn Result Code Control
Result codes are informational messages sent from the modem and displayed
on your monitor.
Q0* Enables modem to send result codes to the DTE.
Q1 Disables modem from sending result codes.
Result Codes:
OK n = 0, 1
ERROR Otherwise
T Select Tone Dialing
This command instructs the modem to send DTMF tones while dialing.
Vn DCE Response Format
This command controls whether result codes are displayed as words or their
numeric equivalents.
V0 Displays result codes as numeric.
V1* Displays result codes as text.
Result Codes:
OK n = 0, 1
ERROR Otherwise
Wn Result Code Option
W0 Display ” CONNECT DCE speed?without V42/MNP extended.
W1 Display ” CONNECT DTE speed?without V42/MNP extended.
W2* Display ” CONNECT DCE speed?with V42/MNP extended.
W3 Display ” CONNECT DTE speed?with V42/MNP extended.
Result Codes:
OK n = 0, 1, 2
ERROR Otherwise
Xn Result Code Selection and Call Progress detection
This command enables tone detection options during dialing procedure. As
these functions are chosen, the modem chip set result codes are also affected.
Therefore, this command is frequently used to control the modem chip set
responses and dial tone detection.