User manual

USER MANUAL

The unit is supplied with a power plug appropriate to its voltage and

destination. Should any other connections be required they must be

carried out with the following configuration.

DMX-512 connection between fixtures

The fixture is equipped with 2-pin XLR sockets for DMX input and output. The

sockets are wired in parallel. Only use a shielded twisted-pair cable designed for

3-pin XLR-plugs and connectors in order to connect the controller with the fixture

or one fixture with another.

Occupation of the XLR-connection

Caution: At the laser fixture, the DMX-cable has to terminated with a

terminator. Solder a 120 Ohm resistor between Signal (-) and

Signal (+) into a 3-pin XLR-plug and plug and plug it in the

DMX-output of the last fixture.

Cable(EU) Cable(US) Pin International

Brown Black Live L

Liht blue White Neutral N

Yellow/Green Green Earth