Installation Guide

MB1 Mailbox with 2” Round In-Ground Mailbox Post (Model 7680)
Assembly Instructions
Assembly Instructions
Thank you for purchasing this premium mailbox and post. We know you'll be satisfied with the years of service it will provide. If you have any
questions about how to assemble or install this product, or if you need any replacement parts, please call us directly at [phone] or
contact us at [e-mail].
© 2018, Architectural Mailboxes, LLCRev. E
www.architecturalmailboxes.com [phone]
R
Hardware (included)
To attach the mailbox to the plate:To join the two post pieces:
x 8, small washers
x 4, small hex bolts
x 4, small hex nuts
1
Phillips head screwdriver
Tools (not included)
Two open end wrenches
- or -
Tools (included)
Hex wrench
x 2, headless set screws
x 1, metal expansion joiner
DO NOT install into ground until both post pieces are securely connected using the expansion joiner.
!
Lay post pieces and the metal expansion
joiner on a flat surface. Then, insert the joiner
into one post piece making sure to align the
screw holes.
Insert the headless set screw into the hole and
tighten with the hex wrench.Tighten the screw
until resistance is felt. Then, tighten at least
another rotation to ensure the joiner is locked in
place as shown in the diagram below.
Correct Post Assembly Incorrect Post Assembly
Set screw
completely
recessed.
a.
b.
c.
Repeat step 1b to properly assemble the
second post piece, making sure to
minimize the gap between the post
pieces.
Expansion joiner is
making contact with
the post.
Set screw is
making contact
with the
expansion
joiner.
Set screw is
not making
contact with the
expansion
joiner.
Install the assembled post into
the ground. Pay particular
attention to the location,
height, and distance from the
street.
Set screw is
exposed.
Expansion joiner is
not making contact
with the post.
31
2
x 2, hole plugs
Mount the mailbox onto the
top bracket and secure with
the 4 hex bolts, 8 washers,
and 4 hex nuts.
Lastly, insert hole plugs to fill
the two joint holes.
x4
x4
hole plugs x2
3
CONTACT THE LOCAL POST OFFICE BEFORE INSTALLING THE MAILBOX TO ENSURE ITS CORRECT PLACEMENT AND HEIGHT AT THE STREET. GENERALLY, MAILBOXES ARE INSTALLED AT A HEIGHT OF 41-45
INCHES FROM THE ROAD SURFACE TO INSIDE FLOOR OF THE MAILBOX OR POINT OF MAIL ENTRY (LOCKED DESIGNS) AND ARE SET BACK 6-8 INCHES FROM THE FRONT FACE OF CURB OR ROAD EDGE TO
THE MAILBOX DOOR.
A concrete footing is highly
recommended. Typical post
depths range from 12”-18” and
may vary based on your
installation application.