Installation Guide

Standard 3” Round In-Ground Mailbox Post (Model 7516)
Assembly Instructions
Assembly Instructions
Thank you for purchasing this premium mailbox post. We know you'll be satisfied with the
years of service it will provide. If you have any questions about how to assemble or install this
product, or if you need any replacement parts, please call us directly at [phone] or
contact us at [e-mail].
The method for installing the mailbox onto the post and the post into the
ground depends on the type of mailbox being used. Refer to the instructions
included with your mailbox for the remainder of the installation.
If your mailbox has holes in the floor, use the 4 large hex bolts, 8 large
washers and 4 large hex nuts to attach the mailbox to the top of the plate.
If your mailbox has holes along its sides, use the 4 long pan head screws
and 4 small hex nuts to attach the mailbox to the side of the plate. For wide
mailboxes, you may want to use the 4 spacers included.
3
Tools
Two Crescent or Open End Wrenches
(not included)
- or -
1
Slide the Top Plate onto
the Post end until the bolt
holes are aligned.
2
Attach the Top Plate to the Post
using the 4 medium hex bolts, 8
medium washers and 4 medium
hex nuts.
Hardware
x 8, large washers
x 4, large hex nuts
x 4, large hex bolts
(used for holes on top of plate)
To attach the mailbox to the top plate:
© 2017, Architectural Mailboxes, LLC
Rev. B
www.architecturalmailboxes.com [phone]
R
x 4, spacers
(not used for all configurations)
x 8, medium washers
x 4, medium hex nuts
x 4, medium hex bolts
To attach the top plate to the post:
x 4, long pan head screws
(used for holes on the side of plate)
x 4, small hex nuts