Installation Guide

Mounting and Use Instructions
Thank you for purchasing this premium locking mailbox. We know you'll be satisfied with the years of service it will provide. If you have any questions about how to mount or
use this mailbox, or if you need any replacement parts, please call us directly at [phone] or contact us at [e-mail].
Mounting your new mailbox
The mail carrier will lift the upper lid and deliver your mail through the slot. Your new mailbox comes with two keys. To retrieve your mail,
unlock the lock with one of your keys and lift both the upper and lower lids. After retrieving your mail, close the lids and re-lock the lock.
Using your new mailbox
3
X 2
For brick or other masonry wall,
insert a plastic anchor
(included) into each hole. Tap
in gently if necessary. This step
is not required if mounting on a
wood wall.
[phone] www.architecturalmailboxes.com © 2017, Architectural Mailboxes 2572 Rev B
R
2
X 2
1/4" masonry bit
- or -
1/16" wood bit
Drill into the wall at each marked location. Use
a 1/4" drill bit for brick or other masonry wall.
Use a 1/16" drill bit for wood wall.
4
A) Screw two of the included screws into holes
almost all the way, allowing enough space to slide the
bottom mailbox holes snugly over the screw heads.
B) While holding the mailbox against the wall, mark
the wall at the center of the two top holes, then
remove the box by lifting and sliding it off the two
bottom screws.
C) Repeat steps 2 and 3 for the two top holes.
D) Remount the box by sliding it back onto the bottom
screws and securing it with the top screws.
1
Mount the mailbox under an eave or
other protected area. While holding
these instructions against the wall at the
desired location, mark the wall at the
center of each dot at the bottom of this
page. These marks represent the
bottom mailbox hole locations. Use a
level to make sure the page is
positioned correctly.
Use this guide to mark the bottom hole location - make sure the page is level before marking.
X 2
Instructions