Instructions / Assembly

1
PRE
PARATION
PACKAGE CONTENTS
Before beginning installation of the product, make sure
all parts are present. If any part is missing or damaged,
do not attempt to assemble, install or operate the
product.
Estimated Assembly Time: 10 Minutes
For 5 years from the date of purchase, this product is warranted for the original purchaser to be free from defects in
materials and workmanship through normal use. In order to obtain this service, please return this item to the place of
purchase with valid proof of purchase and the defective product will be replaced at no charge. This guarantee gives
you specific legal rights, and you may have other rights that vary from state to state.
This grow light was carefully packed and thoroughly inspected before leaving our factory.
ARCHIPELAGO LIGHTING | MONTCLAIR, CA [phone] FAX [phone] www.archipelagolighting.com| | |
A Fixture Assembly
B
C
Chains
D
“J” Hooks
Wall anchors
PART
DESCRIPTION QUANTITY
1
2
2
2
E S Connectors 2
LIMITED WARRANTY
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install the product
WARNING: RISK OF SHOCK
House electrical current can cause painful shock or serious injury unless handled properly. For your safety, always
remember to:
-
Turn of
f the power at the fuse or circuit breaker box before you install the grow light.
2.
This grow light is designed for use in a circuit protected by a fuse or circuit breaker. This grow light is intended to be
directly beneath a ceiling-mounted receptacle and any excess cord should be kept out of the workspace. It isinstalled
installed in accordance with local electrical codes. If you are unsure about your wiring, consult aalso designed to
electrical inspector, and consult your electrical code.qualified electrician or local
3. Account for small parts and destroy packing material, as these may be hazardous to children.
4. WARNING: RISK OF INJURY
Do not open grow light. No serviceable parts inside.
5. WARNING: RISK OF FIRE
Most dwellings built before 1985 have a supply wire rated 60˚C. Do not overload the circuit and wiring. Consult a
electrician. qualified
6. Operation is subject to the following 2 conditions:This device complies with part 15 of the FCC Rules.
(2) this device must accept any interference received, including(1) This device may not cause harmful interference, and
equipment has been tested and found to comply with theinterference that may cause undesired operation. Note: This
Rules. These limits are designed to provide reasonablelimits for a Class B digital device, pursuant to part 15 of the FCC
This
equipment generates, uses and can radiate radioprotection against harmful interference in a residential installation
instructions, may cause harmful interference tofrequency energy and, if not installed and used in accordance with the
will not occur in a particular installation. If thisradio communications. However, there is no guarantee that interference
which can be determined by turning theequipment does cause harmful interference to radio or television reception,
or more of the following measures:equipment of and on, the user is encouraged to try to correct the interference by one
and receiver. Connect theReorient or relocate the receiving antenna. Increase the separation between the equipment
the dealer or anequipment into an outlet on a circuit different from that to which the receiver is connected. Consult
experienced radio/TV technician for help.
1.
!
!
!
!
5012662
A
D
C
B
E
LED GROW LIGHT
MODEL: GL-3/2/23/RBS/2RM
INSTALLATION INSTRUCTIONS