Assembly Instructions

STEP 4B ASSEMBLING THE KENNEL FRAMEWORK - 10ft.x10ft. ONLY (see pg. 4 for 5ft. x 15ft. /pg. 5 for 5x10 / pg. 8 for 8ft. x 6.5ft.)
STEP 5B
STEP 6B
STEP 7B
G
E
A
D
C
F
RECEIVER
TUBES
Fig. 1
Attach CENTER STAND (F) to the other side of the upper and lower end rails. Next, attach UPPER & LOWER SIDE
RAILS (G) to the open end of CENTER STAND (F). Tighten set screws. Do not over tighten.
Attach CORNER STAND WITHOUT ROD CLIPS (C) to the other side of the upper & lower side rails.
Tighten set screws. Do not over tighten. You can now carefully stand this side upright.
E
E
G
G
G
GATE “A”. Slide END RAIL “E”
THROUGH the tubes on the top
and bottom of the gate
C
C
D
C
F
F
G
G
F
F
G
C
C
G
G
G
G
G
G
G
G
G
E
E
E
F
F
F
Page 7