Assembly Instructions

1
a
Attach casters to front (F1) and back (B1) leg frames.
1
b
Create the base by attaching center (C1) shelf panel
to front (F1) and back (B1) leg frames with long hex
screws.
→
Tray stops in the frame corners on (B1) should be flush
with cage exterior.
2
a
Create the first floor. Slide the corner posts of the
front (F2) and back (B2) lower panels into corre-
sponding openings on top corners of (F1) and (B1)
leg frames.
→ Front (F2) and back (B2) lower panels have openings
in the top surface corners (see detail [a]).
→ Some screw holes may not be thoroughly punched
and may still contain the slug. Extract slugs with needle
nose pliers before assembling.
2
b
Add side rails (L1) and (R1).
Side rails are interchangeable.
Attach side rails with a long
hex screw in each corner.
2
c
Set the bottom grille (C2) panel (without hatch
door) into place.
steps
3
a
Create the second floor. Slide the corner posts of
the front (F3) and back (B3) upper panels into corre-
sponding openings on top corners of (F2) and (B2)
lower panels.
Attach (F3) and (B3) upper panels with a long hex
screw in each bottom corner (see detail).
3
c
Add the side (L3) and (R3) upper panels. Attach (L3)
and (R3) panels with a long hex screw in each bottom
and top corner.
3
b
Set the second level grille (C3) panel (with hatch
door) into place.
→ (C3) grille contains a removable separator door,
which can be taken off for full-cage activity or
replaced to create two separate cage spaces.
Secure the (C3) grille with a short hex screw
in the center on each side.
2
d
Add the side (L2) and (R2) lower panels. All
side panels are interchangeable.
→ Orient all side panels with ‘L’ track at the top,
facing cage interior (see detail [b]).
Attach side panels with a long hex screw in
each bottom corner. Leave the top screw out
until Step 3c.
F1
C1
L1
R1
B2
F2
C2
L2
R2
L3
R3
F3
C3
B1
B3
(a)
(b)