Care & Use Guide

Wood Bedside Ramp

Care & Use Guide

We are dedicated to offering innovative solutions to improve pets’ mobility. Please feel free to contact us

with any questions, comments, or warranty issues. Thank you for your purchase!

Cleaning: The wood sections can be cleaned with a

mp cloth or furniture cleaner. Carpet sections can be

treated with household carpet cleaner.

Limited Warranty

Thank you for purchasing this Wood Bedside Ramp. The package should contain: two 31-inch platforms with

carpet; one 12-inch platform with carpet; two curved back legs; one back leg brace; two straight support braces;

one polybag, including twenty screws, twenty washers, four cap nuts, a hex wrench and open wrench.

To asse

mble, prepare a clean, flat area approximately 7 ft long. Lay the 12-inch platform

carpet-side down and locate the two pairs of threaded inserts on the underside. Position

one curved leg so the smooth side of the leg faces “out”, one of the lower mounting

blocks overhangs the edge of the platform, and the holes in the other lower mounting

block align with the threaded inserts (see Fig. 1). Insert two screws with washers and

tighten with provided hex wrench. Repeat for second leg.

Position the back leg brace so the curved side faces up and the four holes align with the

holes in the upper mounting blocks. Insert four screws (without washers) through the

blocks then through the leg brace and fasten with four each cap nuts and washers.

Find the 31-i

nch platform with 8 threaded inserts on the underside. Position this

platform so the two pairs of inserts spaced 3 inches apart are under the overhanging

lower mounting blocks of the back legs. Rotate the back legs slightly to align the

holes in the mounting blocks with the threaded inserts in the 31-inch section.

Insert four screws and washers and tighten. The assembly should now appear as

in Fig. 2.

Position the remaining 31-inch platform so the four threaded inserts are closest to

the already-assembled parts. Place one of the straight support braces over the

two 31-inch platforms so the four holes in the brace align with the threaded

inserts in each platform. Insert four screws and washers and tighten. Repeat

with remaining brace so the ramp appears as in Fig. 3. Assembly is now

complete and the Bedside Ramp can be placed in position for use.